This is a just the sticker sheet with an adhesive side for replacing the sheet on your Cool or hot Plate.
X1 Series and P1 Series
Recommended settings for Bambu Cool Plate
Please note that other slicer settings might need to be adjusted based on the printed model and the filament requirements.
|Hotbed Temperature||Glue Stick Required?||Upper Glass Cover Plate Removed?|
The sheet is easy to replace and install.
- After tearing off the original sheet, please use alcohol to wipe the surface clean. Make sure the surface stays dry while applying a new sheet.
- You can use an anhydrous ethanol solution or isopropanol solution with a concentration of over 90% to wipe the plate.
- You can also use detergent and water to clean the surface.
- It is also best to use special solid glue (Glue Stick for Build Plate) before printing to avoid damage during model removal.