Bambu Lab Liquid Glue for Build Plate, 60 mL

Stop losing prints to warping and lifted corners. Bambu Lab Liquid Glue lays down an even layer that holds your first layer tight while it prints, then lets the part pop off once the plate cools. It is low odour, water based and rinses off with plain water.

What's Included

• 1 bottle of Bambu Lab Liquid Glue, 60 mL
• Built in applicator tip with a push valve
• About 100 full plate coats per bottle

Bed Temperature Guide

If a part still lifts, raise the bed a few degrees within its range.

How to Use

1. Make sure the plate is clean, dry and free of grease.
2. Take off the cap and press the tip on the plate. This opens the valve.
3. Spread an even coat over the whole print area. Press gently. Do not squeeze the bottle.
4. Put the plate on the bed and start your print. The bed heats up and dries the glue for you.
5. When you are done, rinse the plate and the bottom of the part with water.

Works With

• Bambu Lab build plates, including the Textured PEI, Smooth PEI, Engineering, Cool and High Temperature plates
• PLA, PETG, PET, ABS, ASA and TPU

The Bambu Cool Plate SuperTack is made to grip without glue, so you can skip it there.

Good To Know

• Less mess than a glue stick. It goes on smooth and leaves less residue on your parts.
• One good coat works best. Piling on more coats does not add grip.
• On a Textured PEI plate, a coat helps strong sticking materials like PETG let go, so the plate stays safe.
• Let the plate cool before you pull the part. It comes off easier and the part stays clean.
• If there is a lot of glue build up, wash the plate before your next print.
• Store it in a cool, dry place out of the sun.
• Read the Safety Data Sheet (PDF)

Other Ways To Stick

• Creality 3D Printer Glue Stick is a low cost solid stick that is easy to toss in a tool box.
• Menhir Xtreme Lock • Build Plate Adhesive is a strong hold liquid for tough jobs and engineering materials.

FAQ

Do I need to wait for the glue to dry?
No. Once it turns into a film and no longer strings, you can print. The bed warm up finishes the job. A hot bed at 70 °C dries it in about 2 minutes.

How do I clean it off?
Rinse with water and wipe with a soft, lint free cloth.

How long does a bottle last?
About 100 full plate coats.

Does it smell?
It is low odour and water based, so it is easy to use at home or in a classroom.

Will it work on my plate?
It works on all current Bambu Lab plates. The SuperTack plate grips on its own, so it does not need glue.

Good For

• Large flat parts that like to warp
• PETG on PEI, so parts release without hurting the plate
• ABS and ASA prints that need a firm first layer
• Busy print farms and classrooms that want quick, clean plate prep